CLI commands
VLAN interface context
2-72
VLAN interface context
Path: View > Enable > Config > Port 2 port interface > VLAN interface
View > Enable > Config > Port 1 port interface > VLAN interface
View > Enable > Config > Local mesh > VLAN interface
Use this context to configure VLANs.
end
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
end
Switches to parent context.
ip address
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip address <ip address>/<mask>
Sets a static IP address for the VLAN.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
ip address mode
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip address mode (dhcp | static | none)
Sets the IP addressing mode for this VLAN interface.
Parameters
dhcp Dynamic host configuration protocol. The DHCP server will automatically
assign an address to the AP, which functions as a DHCP client.
static This option enables you to manually assign an IP address to the AP.
none This VLAN does not have an IP address.
To Next Page
Loading...
