CLI commands
Local mesh context
2-75
accept forced links
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
accept forced links
(Alternate Master, Slave only) When enabled, the node will accept any connection forced from a
master and it will change its mesh ID in order to use the master mesh ID.
no accept forced links
Ignore forced links.
allowed downtime
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
allowed downtime <number>
The maximum time (in seconds) that a link can remain idle before the link actually gets deleted.
When a slave (or alternate-master) loses its link to its master, the discovery phase is re-initiated.
dynamic local mesh
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dynamic local mesh
Use dynamic local mesh.
no dynamic local mesh
Use static local mesh.
dynamic mode
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dynamic mode(master|alt-master|slave)
Selects the mode of operation for dynamic mode.
Three different roles can be assigned to a local mesh node: master, alternate master, or slave.
Each role governs how upstream and downstream links are established by the node.
Parameters
<master> Root node that provides the upstream link to the root network that the
other nodes want to reach. The master never tries to connect to any other
node. It waits for links from downstream alternate master or slave nodes. .
<alt-master> First establishes an upstream link with a master or alternate master node.
Next, operates as a master node waits for links from downstream alternate
master or slave nodes.
<slave> Can only establish an upstream link with master or alternate master node.
Slave nodes cannot establish downstream links with other nodes.
initial discovery time
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
initial discovery time <number>
(Alternate Master, Slave only) Amount of time that will be taken to discover the best available
master node.
To Next Page
Loading...
Need help?
General
