CLI commands
WAN IP interface context
2-51
WAN IP interface context
Path: View > Enable > Config > WAN IP interface
Use this context to configure various IP-networking related settings on the Internet port.
pppoe client user
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
pppoe client user <username> <password>
Sets the PPPoE username and password.
no pppoe client user
Deletes the PPPoE username.
Parameters
<username> The username assigned to you by your ISP. The AP will use this username
to log on to your ISP when establishing a PPPoE connection.
<password> The password assigned to you by your ISP. The AP will use this username
to log on to your ISP when establishing a PPPoE connection.
ip address mode
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip address mode (dhcp | pppoe | static)
Sets the IP addressing mode for Port 2.
Parameters
dhcp Dynamic host configuration protocol. The DHCP server will automatically
assign an address to the AP, which functions as a DHCP client.
pppoe Point-to-point protocol over Ethernet. The PPPoE server will automatically
assign an IP address to the AP. You need to supply a username and
password so the AP can log on.
static This option enables you to manually assign an IP address to the AP.
ip address
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip address <ip address>/<mask>
Sets a static IP address for the port.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
ip default-gateway
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip default-gateway <ip address>
Sets the IP address of the default gateway.
To Next Page
Loading...
Need help?
General
