CLI commands
Wireless context
2-57
dot11 automatic frequency period
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dot11 automatic frequency period (disabled | 1h | 2h | 4h | 8h | 12h | 24h)
Specify how often the frequency setting is re-evaluated when automatic frequency selection is
enabled.
dot11 automatic frequency time
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dot11 automatic frequency time <time>
Specify when the channel should be re-evaluated.
dot11 automatic transmit-power
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dot11 automatic transmit-power
Enables automatic transmit power selection.
no dot11 automatic transmit-power
Disables automatic transmit power selection.
dot11 automatic transmit-power period
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dot11 automatic transmit-power period (1h | 2h | 4h | 8h | 12h | 24h)
Sets the interval at which the transmit power setting is re-evaluated when automatic power
selection is enabled.
New maximum clients
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
maximum clients <value>
Sets the maximum number of wireless client stations that can be associated at the same time on
this radio.
Parameters
< value> Maximum clients value in the range 1 and 255.
multicast rate
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
multicast rate (1 | 2 | 5.5 | 6 | 9 | 11 | 12 | 18 | 24 | 36 | 48 | 54)
Sets the transmit rate for multicast traffic.
This is a fixed rate, which means that if a station is too far away to receive traffic at this rate, then
the multicast will not be seen by the station. By rasing the multicast rate you can increase overall
throughput significantly.
To Next Page
Loading...
Need help?
General
