CLI commands
Wireless context
2-58
station distance
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
station distance (0km | 5km | 10km | 15km | 20km | 25km | 30km | 35km)
Fine tunes internal timeout settings to account for the distance that wireless links span. For
normal operation, the AP is optimized for links of less than 1 km.
This is a global setting that is useful when creating wireless links to remote sites. However, it also
applies to all wireless connection made with the radio, not just for wireless links. Therefore, if you
are also using the radio to serve local wireless client stations, adjusting this setting may lower the
performance for clients with marginal signal strength or when interference is present.
(Essentially, it means that if a frame needs to be retransmitted it will take longer before the actual
retransmit takes place.)
dot11 mode
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dot11 mode (monitor | ap+wds | ap-only | wds-only | sensor)
Sets the operating mode for the radio.
spectralink view
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
spectralink view
Enables the use of spectralink view.
no spectralink view
Disables the use of spectralink view.
New dot11n channel extension
Supported on: MSM422 MSM410
dot11n channel extension (above | below)
Selects the 802.11n channel extension. Applicable only in the 2.4 GHz band and a 40 MHz channel
width.
dot11n channel width
Supported on: MSM422 MSM410
dot11n channel width (40 | 20 | auto)
Select the 802.11n channel width.
New dot11n guard interval
Supported on: MSM422 MSM410
dot11n guard interval (short | long)
Selects the 802.11n guard interval.
To Next Page
Loading...
Need help?
General
