HP ProCurve MSM310 - Enable Context

CLI commands
Enable context
2-4
Enable context
Path: View > Enable
This context provides access to various utilities.
reboot device
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
reboot device
Restarts the system.
show certificate
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
show certificate
Displays current certificates.
show certificate binding
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
show certificate binding
Displays how the certificates are used.
iperf
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
iperf -c host [-t time]
Runs a performance throughput test.
Parameters
<-c host> The IP address or DNS name of the iperf server to connect to.
<-t length> Length of the throughput test in seconds.
ping
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ping <host> [-c <count>] [-s <length>] [-q]
Determines if the specified remote IP address is active.
Parameters
<-c host> The IP address or DNS name of the host to ping.
<-c count> Number of pings.
<-s length> Length of the ping datagram.
<-q> Quiet mode. No output.