Index
N S
network interface controller (NIC),
specifications 5-7
screwdriver symbol 2-3
SCSI cable routing 2-12
NIC See network interface controller seek time, hard drive 5-5, 5-6
serial port connectors 4-3, 4-5
server components
O
exploded view (ATA model), illustrated 1-4
operating temperature, hard drive 5-5, 5-6
exploded view (SCSI model), illustrated 1-5
spare parts list 1-6, 1-7
P
server LEDs 4-13
server specifications 5-1
panel access, part number 1-3
signal cable kit, part number 1-7
parallel port connector 4-3, 4-5
single-channel Wide Ultra3 SCSI controller,
specifications 5-7
PCI boards, configuring automatically 3-3
personal injury, warning 2-3, 2-5, 2-7, 2-34
SmartStart 3-3
plastics kit, miscellaneous 1-3
SmartStart Diskette Builder 3-3
POST (Power-On Self-Test) 3-4
specifications
power button, part number 1-7
CD-ROM drive 5-4
power cable kit, part number 1-7
diskette drive 5-3
power cords, disconnecting, warning 2-5
hard drives 5-5
power extension cable, part number 1-7
memory 5-3
power fluctuations, caution 2-5
NIC 5-7
power LED, front panel 4-13
server unit 5-2
Power On/Standby LED 4-13
Ultra ATA 100 controller 5-8
power shield cable, part number 1-7
Wide Ultra3 SCSI controller 5-7
power source, warning 2-3
Wide Ultra3 SCSI hard drive 5-6
power supply
standby mode LED 4-13
connectors 4-3, 4-5
storage device, maximum supported 2-8
part number 1-6
stripe size 2-23
removing 2-38
Survey Utility 3-2
replacing 2-38
switch settings, obtaining 3-3
power switch assembly connector 4-5
switch, power, removing 2-24
power switch, removing 2-24
switches See also system configuration switch or
system ID switch
powering down server 2-4
preparing for service procedure 2-4
described 4-9
processor
symbols
part number 1-6
on equipment 2-3
removing 2-34
system board
replacing 2-36
components 4-2, 4-4
processor socket, locating 2-33
illustrated 4-5
part number 1-6
R
removing 2-37
replacing 2-37
RBSU (ROM-Based Setup Utility) 2-41, 3-3
system configuration switch
rear panel connectors 4-6
location 4-3, 4-5
removable media bay device, replacing 2-27
settings 4-10
removable media bezel blank, part number 1-3
System Firmware Update 3-3
repairs, warning 2-4
system ID switch
resource conflict, resolving 3-3
location 4-3, 4-5
return kit, part number 1-7
settings 4-11
RJ-45 receptacle, warning 2-3
ROM-Based Setup Utility See RBSU
ROMPaq Utility 3-3
rubber bumpers, part number 1-3
HP ProLiant ML310 Server Maintenance and Service Guide Index-3
To Next Page
Loading...
