162 Fabric OS Administrator’s Guide
53-1002446-01
Policy database distribution
7
Example shows the database distribution settings
switch:admin> fddcfg --showall
Local Switch Configuration for all Databases:-
DATABASE - Accept/Reject
---------------------------------
SCC - accept
DCC - accept
PWD - accept
FCS - accept
AUTH - accept
IPFILTER - accept
Fabric Wide Consistency Policy:- ""
Enabling local switch protection
1. Connect to the switch and log in using an account with admin permissions, or an account with
OM permissions for the FabricDistribution RBAC class of commands.
2. Enter the fddCfg
--localreject command.
Disabling local switch protection
1. Connect to the switch and log in using an account with admin permissions, or an account with
OM permissions for the FabricDistribution RBAC class of commands.
2. Enter the fddCfg
--localaccept command.
ACL policy distribution to other switches
This section explains how to manually distribute local ACL policy databases. The distribute
command has the following dependencies:
• All target switches must be running Fabric OS v6.2.0 or later.
• All target switches must accept the database distribution (see “Database distribution settings”
on page 161).
• The fabric must have a tolerant or no (absent) fabric-wide consistency policy (see “Fabric-wide
enforcement” on page 163).
If the fabric-wide consistency policy for a database is strict, the database cannot be manually
distributed. When you set a strict fabric-wide consistency policy for a database, the distribution
mechanism is automatically invoked whenever the database changes.
• The local distribution setting must be accepted. To be able to initiate the distribute command,
set the local distribution to accept.
Distributing the local ACL policies
1. Connect to the switch and log in using an account with admin permissions, or an account with
OM permissions for the FabricDistribution RBAC class of commands.
2. Enter the distribute -p command.
To Next Page
Loading...
Need help?
General