HP SN3000B User Manual

Fabric OS Administrator’s Guide 333
53-1002446-01
Supported switches and configurations for FA-PWWN
16
4. Enable the FA-PWWN on the HBA. The following steps are to be executed on the server and not
the switch.
a. Log in to the server as root.
b. Enter the following command:
bcu port -faa port_id --enable
c. Enter the following command:
bcu port -faa port_id --query
Once the Brocade HBA has been assigned the FA-PWWN, the HBA retains the FA-PWWN until it is
rebooted. This means you cannot unplug and plug the cable into a different port on the switch. You
must reboot the HBA before moving the HBA to a different port. If you move an HBA to a different
port on a switch running Fabric OS v7.0.0 or later, the HBA will disable its port. If the HBA moves to
a different port on a switch running a version of Fabric OS earlier than 7.0.0, the HBA will continue
to disable its port.
Supported switches and configurations for FA-PWWN
The FA-PWWN feature is supported on the following platforms:
• Switch platforms running Fabric OS v7.0.0 or later:
- Brocade DCX, DCX-4S, and DCX 8510 family
- Brocade 300
- Brocade 5100
- Brocade 5300
- Brocade 6505
- Brocade 6510
- Brocade VA-40FC
• Access Gateway platforms running Fabric OS v7.0.0 or later:
- Brocade 300
- Brocade 5100
- Brocade 6510
• Brocade HBAs with driver version 3.0.0.0:
- Brocade 415
- Brocade 425
- Brocade 815
- Brocade 825

HP SN3000B Specifications

General

Brand	HP
Model	SN3000B
Category	Switch
Language	English