Fabric OS Administrator’s Guide xxxix
53-1002446-01
• syslog message logs
2. Switch Serial Number
The switch serial number and corresponding bar code are provided on the serial number label,
as illustrated below.:
The serial number label is located as follows:
• Brocade 5424 — On the bottom of the switch module.
• Brocade 300, 5100, and 5300 — On the switch ID pull-out tab located on the bottom of
the port side of the switch.
• Brocade 6510 — On the switch ID pull-out tab located inside the chassis on the port side
on the left.
• Brocade 7800 and 8000 — On the bottom of the chassis.
• Brocade DCX-4S and DCX 8510-4 — On the nonport side of the chassis, on the lower left
side.
• Brocade DCX and DCX 8510-8 — On the port side of the chassis, on the lower right side
and directly above the cable management comb.
3. World Wide Name (WWN)
Use the wwn command to display the switch WWN.
If you cannot use the wwn command because the switch is inoperable, you can get the WWN
from the same place as the serial number, except for the Brocade DCX enterprise class
platform. For the Brocade DCX enterprise class platform, access the numbers on the WWN
cards by removing the Brocade logo plate at the top of the nonport side of the chassis.
For the Brocade 5424 embedded switch: Provide the license ID. Use the licenseIdShow
command to display the WWN.
Document feedback
Quality is our first concern at Brocade and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
documentation@brocade.com
Provide the title and version number of the document and as much detail as possible about your
comment, including the topic heading and page number and your suggestions for improvement.
*FT00X0054E9*
FT00X0054E9
To Next Page
Loading...
Need help?
General