EasyManuals Logo

HP SN3000B User Manual

HP SN3000B
584 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #513 background imageLoading...
Page #513 background image
Fabric OS Administrator’s Guide 475
53-1002446-01
Setting up FC-FC routing
24
1. Connect to the FC router and log in using an account with admin permissions.
2. Enter the fcrXlateConfig
--show command to identify any stale xlate domains.
3. Enter the fcrXlateConfig
--del command to delete the stale xlate domains.
Example
sw0:root> fcrxlateconfig --show stalexd
Imported FID Stale XD Owner Domain
--------------------------------------------------
012 002 007 ( this FCR )
sw0:root> fcrxlateconfig --del stalexd 12 2
Xlate domain 2 is deleted
Setting up FC-FC routing
To set up FC-FC routing, perform the following tasks in the order listed.
1. Verify that you have the proper setup for FC-FC routing. (Refer to “Verifying the setup for FC-FC
routing” on page 475.)
2. Assign backbone fabric IDs. (Refer to “Backbone fabric IDs” on page 477.)
3. Configure FCIP tunnels if you are connecting Fibre Channel SANs over IP-based networks.
(Refer to “FCIP tunnel configuration” on page 478.)
4. Configure IFLs for edge and backbone fabric connection. (Refer to “Inter-fabric link
configuration” on page 478.)
5. Modify port cost for EX_Ports, if you want to change from the default settings. (Refer to “FC
router port cost configuration” on page 482.)
6. Configure trunking on EX_Ports that are connected to the same edge fabric. (Refer to “EX_Port
frame trunking configuration” on page 484.)
7. Configure LSAN zones to enable communication between devices in different fabrics. (Refer to
“LSAN zone configuration” on page 485.)
Refer to Chapter 3, “Performing Advanced Configuration Tasks,” for more details about
configuration options for Brocade Backbones.
Verifying the setup for FC-FC routing
Before configuring a fabric to connect to another fabric, you must perform the following verification
checks on the FC router.
1. Log in to the switch or Backbone as admin and enter the version command. Verify that
Fabric OS v7.0.1 is installed on the FC router as shown in the following example.
switch:admin> version
Kernel: 2.6.14.2
Fabric OS: v7.0.1
Made on: Fri Nov 18 01:15:34 2011
Flash: Mon Nov 21 20:53:48 2011
BootProm: 1.0.9

Table of Contents

Other manuals for HP SN3000B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP SN3000B and is the answer not in the manual?

HP SN3000B Specifications

General IconGeneral
BrandHP
ModelSN3000B
CategorySwitch
LanguageEnglish

Related product manuals