HP SN3000B User Manual

Fabric OS Administrator’s Guide 249
53-1002446-01
Zone creation and maintenance
11
Viewing an alias in the defined configuration
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the aliShow command, using the following syntax
alishow "pattern"[, mode]
If no parameters are specified, the entire zone database (both the defined and effective
configuration) is displayed.
Example
The following example shows all zone aliases beginning with “arr”.
switch:admin> alishow "arr*"
alias: array1 21:00:00:20:37:0c:76:8c
alias: array2 21:00:00:20:37:0c:66:23
Zone creation and maintenance
To create a broadcast zone, use the reserved name “broadcast”. Do not give a regular zone the
name of “broadcast”. See “Broadcast zones” on page 244 for additional information about this
special type of zone.
Virtual Fabrics considerations: Zone definitions should not include logical port numbers. Zoning is
not enforced on logical ports.
Creating a zone
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the zoneCreate command, using the following syntax:
zonecreate "zonename", "member[; member...]"
To create a broadcast zone, use the reserved name “broadcast”.
3. Enter the cfgSave command to save the change to the defined configuration.
The cfgSave command ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this command is run,
the transaction on the other switch is automatically aborted. A message displays on the other
switches to indicate that the transaction was aborted.
Example
switch:admin> zonecreate "greenzone", "2,32; 2,33; 2,34; 4,4"
switch:admin> zonecreate "bluezone", "21:00:00:20:37:0c:66:23; 4,3"
switch:admin> zonecreate "broadcast", "1,2; 2,33; 2,34"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled. Until the Effective
configuration is re-enabled, merging new switches into the
fabric is not recommended and may cause unpredictable
results with the potential of mismatched Effective Zoning configurations.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y

HP SN3000B Specifications

General

Brand	HP
Model	SN3000B
Category	Switch
Language	English