HP SN3000B User Manual

314 Fabric OS Administrator’s Guide
53-1002446-01
Configuring encryption and compression
14
22 No No No No
23 No No No No
144 No No No No
145 No No No No
146 No No No No
147 No No No No
148 No No No No
149 No No No No
150 No No No No
151 No No No No
-----------------------------------------------------
88 No No No No
89 No No No No
90 No No No No
91 No No No No
92 No No No No
93 No No No No
94 No No No No
95 No No No No
208 No No No No
209 No No No No
210 No No No No
211 No No No No
212 No No No No
213 No No No No
214 No No No No
215 No No No No
344 No No No No
345 No No No No
346 No No No No
347 No No No No
348 No No Yes Yes
349 No No Yes Yes
350 No No No No
351 No No No No
Configuring and enabling authentication
To configure authentication for ports that will later be configured for encryption, follow these steps:
1. Log in to the switch using an account with admin permissions, or an account with OM
permissions for the Authentication RBAC class of commands.
2. Enter the secAuthSecret
--set command to establish pre-shared secrets at each end of the
ISL. It is recommended to use a 32 bit secret for an ISL carrying encrypted or compressed
traffic.
secauthsecret --set
When prompted, enter the WWN for the local switch and secret strings for the local switch and
the remote switch.
NOTE
When setting a secret key pair, you are entering the shared secrets in plain text. Use a secure
channel, such as SSH or the serial console, to connect to the switch on which you are setting
the secrets.

HP SN3000B Specifications

General

Brand	HP
Model	SN3000B
Category	Switch
Language	English