To Next Page

To Previous Page

334 Fabric OS Administrator’s Guide

53-1002446-01

Configuration upload and download considerations for FA-PWWN

The configuration upload and download utilities can be used to import and export the FA-PWWN

configuration.

ATTENTION

Brocade recommends you delete all FA-PWWNs from the switch with the configuration being

replaced before you upload or download a modified configuration. This is to ensure no duplicate

FA-PWWNs in the fabric.

Firmware upgrade and downgrade considerations for FA-PWWN

Firmware downgrade is blocked if the FA-PWWN feature is enabled on the switch. All FA-PWWN

configurations are lost if firmware is downgraded, followed by an upgrade back to Fabric OS v7.0.0.

This is done to ensure that the FA-PWWN configurations are not tampered with when the switch is

running an earlier version of the firmware.

You must also consider zone configuration, security configuration, and target ACLs when

downgrading from Fabric OS 7.0.0. If any of these (zone configuration, security configuration, and

target ACLs) have FA-PWWNs configured, the SAN network may not function properly, or at all.

Security considerations for FA-PWWN

The FA-PWWN feature can be enabled only by authorized administrators. Thus, existing user-level

authentication and authorization mechanisms should be used to ensure only authorized users can

configure this feature.

If you are concerned about security for FA-PWWN, you should configure device authentication. You

can use authentication at the device level to ensure security between the switch and the server.

Refer to “Device authentication policy” on page 146 for information about configuring device

authentication.

You can also use the Device Connection Control (DCC) policy to ensure that only an authorized

physical server can connect to a specific switch port.

NOTE

When creating the DCC policy, use the physical device WWN and not the FA-PWWN.

If you use DCC, a policy check is done on the physical PWWN on the servers. In the case of an HBA,

the FA-PWWN is assigned to the HBA only after the DCC check is successful.

Refer to “DCC policy behavior with Fabric-Assigned PWWNs” on page 141 for additional

information.

HP SN3000B User Manual

Other manuals for HP SN3000B