HP SN3000B User Manual

480 Fabric OS Administrator’s Guide
53-1002446-01
Inter-fabric link configuration
24
4. (Optional) Set up ISL or EX_Port trunking. For information on trunking setup, refer to
“Configuring EX_Port trunking” on page 442.
5. Enter the portEnable command to enable the ports that you disabled in step 1.
switch:admin> portenable 7/10
6. Physically attach ISLs from the Fibre Channel router to the edge fabric.
7. Enter th e portCfgShow command to view ports that are persistently disabled.
FC ports on the Brocade 7800 switches and FX8-24 blades are configured as persistently
disabled by default, to avoid inadvertent fabric merges when installing a new FC router.
switch:admin> portcfgshow 7/10
Area Number: 74
Speed Level: AUTO
Trunk Port OFF
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
NPIV capability ON
EX Port ON
Mirror Port ON
FC Fastwrite ON
8. After identifying such ports, enter the portCfgPersistentEnable command to enable the port,
and then the portCfgShow command to verify the port is enabled.
switch:admin> portcfgpersistentenable 7/10
switch:admin> portcfgshow 7/10
Area Number: 74
Speed Level: AUTO
Trunk Port OFF
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
NPIV capability ON
EX Port ON
Mirror Port ON
FC Fastwrite ON
9. Enter either the portCfgEXPort or portShow command to verify that each port is configured
correctly.
switch:admin> portcfgexport 7/10
Port 7/10 info
Admin: enabled

HP SN3000B Specifications

General

Brand	HP
Model	SN3000B
Category	Switch
Language	English