Table 52 Error codes (part code 6010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the contents, and retry.The value specified for Gathering Interval
is invalid. Specify a valid value within
the range of 1 to 15.
51386010
WCheck the contents, and retry.The Script File Name value is invalid.
Specify the correct value.
51396010
WSpecify the correct CU number.The specified CU number is incorrect.
Specify the correct CU number.
51406010
WSpecify the correct device number.The specified LDEV number is incorrect.
Specify the correct LDEV number.
51416010
WSpecify the correct group number.The specified GID is incorrect. Specify
the correct GID.
51426010
WSpecify the correct LUN.The specified LUN is incorrect. Specify
the correct LUN.
51436010
WCheck the entered values, then specify
correct values.
Some of the entered values are incorrect.
Check the values and then specify
correct values.
51446010
EPlease contact HP Technical Support.An error occurred in the client logic.70606010
EPlease contact HP Technical Support.An error occurred in the client logic.73016010
EPlease contact HP Technical Support.An error occurred in the client logic.73026010
EPlease contact HP Technical Support.An error occurred in the client logic.73036010
EIf this problem persists, please contact
HP Technical Support.
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
74406010
WClick [Refresh], and retry.The system cannot apply the new
configuration. Do you want to refresh?
81016010
WClick [Yes] to recover from the error
condition. If not, click [No].
If the recovery fails despite retrying,
suspend the corresponding pair
temporarily, and execute Resume Pair
(Pairresync) operation.
An error occurred when copying started.
Do you want to recover from the error
condition?
89286010
iFollow the instructions in the message.Exchange the channel cable connections
after confirmation of the port type.
90066010
iConfirm that the R-VOLs to specify are
varied off-line.
Please confirm that the R-VOLs to specify
are varied off-line.
90076010
iClick [OK].SIMs of Remote Copy are cleared.90086010
iClick [OK].The export is complete.90096010
iClick [Yes] to continue processing. After
processing is complete, reset the port
that is not in operation.
The Port Setting process has not
completed. Do you want to continue for
other ports?
90216010
iCheck the contents of the main and
remote volumes. If the contents match,
click [OK]. If not, click [Cancel].
WARNING: Initial copy mode 'None'
is selected for some volume pairs. Are
you sure that the M-VOL and the R-VOL
of these pairs are already synchronized?
90226010
Part code 6010 169
To Next Page
Loading...
