• Module Loc—Module in which the drive is installed
• Cooling Fan Status—When the drive cooling fan is operating correctly, the status will be Active.
• Personality—A service engineer might request this information.
• Control Path Failover
◦ Disabled—Control path failover is not enabled for the drive.
◦ Unlicensed—A control path failover license has not been added to the library.
◦ Advanced—LTO-6 advanced control path failover is enabled for the drive. The Active and Passive
drives are designated.
◦ LTO7+ CPF—LTO-7+ control path failover is enabled for the drive. The Active and Passive drives
are designated.
• Manufacturer S/N—The serial number assigned to the drive when it was manufactured. Use this
serial number when working with service.
• WWNN—Worldwide unique number for the drive. The library assigns WWNNs to the drive bays. When
a tape drive is replaced, the WWNN is reassigned to the replacement drive. FC only.
• Partition—Partition to which the drive is assigned.
• Cartridge—Information about the cartridge, if any, currently in the drive.
• Media Removal—Whether the media can be removed from the drive or not. Many host applications
prevent media removal while accessing the cartridge in the tape drive.
• Data Compression—Indicates whether the drive is using data compression.
• Data Path Failover
◦ Advanced—LTO-6 advanced data path failover is enabled.
◦ LTO7+ DPF—LTO-7+ data path failover is enabled.
◦ Disabled—DPF is not enabled for the drive.
◦ Unlicensed—A Data Path Failover license has not been added to the library.
• Fibre Channel Fabric Log-in Name (LTO-6 only)
• Port configuration (FC only)—Drive port status
◦ WWPN—Displays the worldwide port name, a unique identifier for each FC interface.
◦ Speed—Displays the current interface speed.
◦ Port Type
– Automatic
– Loop—Enables selection of the Addressing Mode.
– Fabric (N/F)
◦ Interface—The status of the port connection.
116 Operating the library
To Next Page
Loading...
