Event code Message and description
8009 The timezone configuration has changed.
8010 A new partition was added.
8011 The network settings have changed.
8012 All expansion modules upgraded. The firmware for all expansion modules has been
upgraded.
8013 The NTP time synchronization configuration has changed.
8014 The SSH access was enabled/disabled.
8015 Level of media generation checking has changed.
LTO generation media checking has been enabled or disabled by the user.
8016 Library reset default settings invoked by user. The library settings have been reset to their
default values. See Default and restore defaults settings on page 240.
8017 Library firmware changed. The firmware process was initiated by a user.
8018 The Unlabeled Media Support configuration has changed.
8019 Robotics firmware version upgraded.
8020 A new key was created automatically. A new security token key was created through the
Encryption Kit automatic key generation mode.
8021 Secure Manager status changed.
8022 RMI/OCP Timeout configuration changed.
8023 MSL Encryption Kit / ESKM migration configuration changed.
8024 Mailslot / Magazine access control configuration changed.
8025 Mailslot / Magazine automatic relock duration changed.
8026 Robotics assembly change detected. The robotics assembly has been replaced.
8027 Power board has been exchanged. A drive power board has been exchanged or added.
8028 Power supply has changed. A power supply has been moved within the library or
replaced.
8029 The SNMP configuration changed.
8030 An SNMP target has been added.
Table Continued
Event codes 233
To Next Page
Loading...
