Event code Message and description
8031 An SNMP target has been deleted.
8032 The SNMPv3 settings changed.
8033 The OCP module has been changed.
8034 Manual drive reset executed. A drive reboot was requested through the RMI or by the
library. This process could cause side effects if done while the library is operating.
8035 Chassis calibration data has been changed.
8036 New chassis detected. One of the modules has been replaced.
8037 Chassis has been removed. One of the expansion modules has been removed from the
library.
8038 New hardware component first time detected in this library and added to system
configuration.
The library detected a new replaceable hardware component, such as a power supply,
power board, or chassis fan, and has started monitoring the new component. Removing
the component will create an alert and set the library in warning status.
8039 Hardware autodetection status reset to default values.
8040 LDAP server has been added.
8041 LDAP server has been modified.
8042 LDAP server has been deleted.
8043 LDAP user has been added.
8044 LDAP user has been modified.
8045 LDAP user has been deleted.
8046 Logout prevention configuration changed.
8047 FIPS Secure Mode configuration changed.
8056 Command View TL configuration changed.
234 Event codes
To Next Page
Loading...
