HPE FlexFabric 5700 Series Configuration Guide

169
Step Command Remarks
3. Configure the authentication
mode for multihop BFD
control packets.
bfd multi-hop
authentication-mode
{
m-md5
|
m-sha1
|
md5
|
sha1
|
simple
}
key-id {
cipher
cipher-string |
plain
plain-string }
By default, no authentication is
performed.
4. Set the destination port
number for multihop BFD
control packets.
bfd multi-hop destination-port
port-number
The default setting is 4784.
5. Set the multihop detection
time multiplier.
bfd multi-hop detect-multiplier
value
The default setting is 5.
6. Set the minimum interval for
receiving multihop BFD
control packets.
bfd multi-hop
min-receive-interval
value
By default, the minimum interval
for receiving multihop BFD control
packets is 400 milliseconds.
7. Set the minimum interval for
transmitting multihop BFD
control packets.
bfd multi-hop
min-transmit-interval
value
By default, the minimum interval
for transmitting multihop BFD
control packets is 400
milliseconds.
Configuring a BFD template
Perform this task to specify BFD parameters in a template for sessions without next hops. You can
configure BFD parameters for LSPs and PWs through a BFD template.
To configure a BFD template:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a BFD template and
enter BFD template view.
bfd template
template-name
By default, no BFD template is
created.
3. Configure the authentication
mode for BFD control
packets.
bfd authentication-mode
{
m-md5
|
m-sha1
|
md5
|
sha1
|
simple
} key-id {
cipher
cipher-string |
plain
plain-string }
By default, no authentication is
performed.
4. Set the detection time
multiplier.
bfd detect-multiplier
value The default setting is 5.
5. Set the minimum interval for
receiving BFD control
packets.
bfd min-receive-interval
value
By default, the minimum interval
for receiving single-hop BFD
control packets is 400
milliseconds.
6. Set the minimum interval for
transmitting BFD control
packets.
bfd min-transmit-interval
value
By default, the minimum interval
for transmitting single-hop BFD
control packets is 400
milliseconds.
Displaying and maintaining BFD
Execute the display command in any view and the reset command in user view.

HPE FlexFabric 5700 Series Specifications

General

Product Line	HPE FlexFabric
Model	5700 Series
Power Supply	Redundant power supply options
Layer Support	Layer 2/3
Management	HPE Intelligent Management Center (IMC), CLI, SNMP
Routing Protocol	RIP, OSPF, BGP, IS-IS
Features	Virtualization
Compliant Standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3ae
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	10% to 90% (noncondensing)
Latency	Less than 1 µs