HPE FlexFabric 5700 Series

61
# Configure Device B as the transit node of primary ring 1, with Ten-GigabitEthernet 1/0/1 as
the primary port and Ten-GigabitEthernet 1/0/2 as the secondary port. Enable ring 1.
[DeviceB-rrpp-domain1] ring 1 node-mode transit primary-port ten-gigabitethernet
1/0/1 secondary-port ten-gigabitethernet 1/0/2 level 0
[DeviceB-rrpp-domain1] ring 1 enable
[DeviceB-rrpp-domain1] quit
# Enable RRPP.
[DeviceB] rrpp enable
3. Configure Device C:
Configure Device C in the same way Device B is configured.
4. Configure Device D:
Configure Device D in the same way Device B is configured.
Verifying the configuration
# Use the display commands to view RRPP configuration and operational information on each
device.
Intersecting ring configuration example
Network requirements
As shown in Figure 20:
• Device A, Device B, Device C, Device D, and Device E form RRPP domain 1. VLAN 4092 is the
primary control VLAN of RRPP domain 1. RRPP domain 1 protects VLANs 1 through 30.
• Device A, Device B, Device C, and Device D form primary ring 1. Device B, Device C, and
Device E form subring 2.
• Device A is the master node of primary ring 1, with Ten-GigabitEthernet 1/0/1 as the primary
port and Ten-GigabitEthernet 1/0/2 the secondary port.
• Device E is the master node of subring 2, with Ten-GigabitEthernet 1/0/1 as the primary port
and Ten-GigabitEthernet 1/0/2 the secondary port.
• Device B is the transit node of primary ring 1 and the edge node of subring 2, with
Ten-GigabitEthernet 1/0/3 as the edge port.
• Device C is the transit node of primary ring 1 and the assistant edge node of subring 1, with
Ten-GigabitEthernet 1/0/3 as the edge port.
• Device D is the transit node of primary ring 1, with Ten-GigabitEthernet 1/0/1 as the primary port
and Ten-GigabitEthernet 1/0/2 the secondary port.