112
• Member ports of Layer 2 aggregation groups
• S-channel interfaces and S-channel aggregate interfaces
Follow these guidelines when you configure monitor link group member interfaces:
• To avoid undesired down/up state changes on the downlink interfaces, configure uplink
interfaces before you configure downlink interfaces.
• To avoid interrupting Monitor Link operation, do not assign the aggregate interface and member
ports of an aggregation group to the same monitor link group.
• An interface can be assigned to only one monitor link group.
In monitor link group view
To configure member interfaces for a monitor link group in monitor link group view:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter monitor link group
view.
monitor-link group
group-id
N/A
3. Configure member interfaces
for the monitor link group.
port
interface-type
interface-number {
downlink
|
uplink
}
By default, a monitor link group
has no member interfaces.
In interface view
To configure member interfaces for a monitor link group in interface view:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view
interface
interface-type
interface-number
N/A
3. Configure the current interface
as a member of a monitor link
group.
port monitor-link group
group-id
{
downlink
|
uplink
}
By default, the interface is not a
monitor link group member.
Configuring the switchover delay for the downlink
interfaces in a monitor link group
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter monitor link group view.
monitor-link group
group-id
N/A
3. Configure the switchover
delay for the downlink
interfaces in the monitor link
group.
downlink up-delay
delay
By default, the switchover delay
for the downlink interfaces is 0
seconds. The downlink
interfaces come up as soon as
an uplink interface comes up.
To Next Page
Loading...
Need help?
General
