HPE FlexFabric 5700 Series Configuration Guide

6
To configure errored symbol event detection on a port:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2/Layer 3
Ethernet port view.
interface
interface-type
interface-number
N/A
3. Configure the errored symbol
event detection window.
oam errored-symbol-period
window
window-value
By default, an interface uses the
value configured globally.
4. Configure the errored symbol
event triggering threshold.
oam errored-symbol-period
threshold
threshold-value
By default, an interface uses the
value configured globally.
Configuring errored frame event detection
An errored frame event occurs when the number of times that error frames in the detection window
(specified detection interval) are detected exceeds the predefined threshold.
You can configure this command in system view or port view. The configuration in system view takes
effect on all ports, and the configuration in port view takes effect on the specified port. For a port, the
configuration in port view takes precedence.
To configure errored frame event detection globally:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the errored frame
event detection window.
oam global errored-frame
window
window-value
By default, the errored frame
event detection window is 1000
milliseconds.
3. Configure the errored frame
event triggering threshold.
oam global errored-frame
threshold
threshold-value
By default, the errored frame
event triggering threshold is 1.
To configure errored frame event detection on a port:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2/Layer 3
Ethernet port view.
interface
interface-type
interface-number
N/A
3. Configure the errored frame
event detection window.
oam errored-frame window
window-value
By default, an interface uses the
value configured globally.
4. Configure the errored frame
event triggering threshold.
oam errored-frame threshold
threshold-value
By default, an interface uses the
value configured globally.
Configuring errored frame period event detection
An errored frame period event occurs when the number of times that frame errors in the detection
window (specified number of received frames) are detected exceeds the predefined threshold.
You can configure this command in system view or port view. The configuration in system view takes
effect on all ports, and the configuration in port view takes effect on the specified port. For a port, the
configuration in port view takes precedence.
To configure errored frame period event detection globally:

HPE FlexFabric 5700 Series Specifications

General

Product Line	HPE FlexFabric
Model	5700 Series
Power Supply	Redundant power supply options
Layer Support	Layer 2/3
Management	HPE Intelligent Management Center (IMC), CLI, SNMP
Routing Protocol	RIP, OSPF, BGP, IS-IS
Features	Virtualization
Compliant Standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3ae
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	10% to 90% (noncondensing)
Latency	Less than 1 µs