135
Disabling an IPv6 VRRP group
You can temporarily disable an IPv6 VRRP group. After being disabled, the VRRP group stays in
initialized state, and its configurations remain unchanged. You can change the configuration of a
VRRP group when it is disabled. Your changes take effect when you enable the VRRP group again.
To disable an IPv6 VRRP group:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Disable an IPv6 VRRP
group.
vrrp ipv6 vrid
virtual-router-id
shutdown
By default, an IPv6 VRRP group is
enabled.
Displaying and maintaining IPv6 VRRP
Execute display commands in any view and the reset command in user view.
Task Command
Display the states of IPv6 VRRP
groups.
display
vrrp ipv6
[
interface
interface-type interface-number [
vrid
virtual-router-id ] ] [
verbose
]
Display statistics for IPv6 VRRP
groups.
display vrrp
ipv6 statistics
[
interface
interface-type
interface-number [
vrid
virtual-router-id ] ]
Clear statistics for IPv6 VRRP
groups.
reset vrrp ipv6 statistics
[
interface
interface-type interface-number
[
vrid
virtual-router-id ] ]
IPv4 VRRP configuration examples
Single VRRP group configuration example
Network requirements
Switch A and Switch B form a VRRP group and use the virtual IP address 10.1.1.111/24 to provide
gateway service for the subnet where Host A resides, as shown in Figure 37.
Switch A
operates as the master to forward packets from Host A to Host B. When Switch A fails,
Switch B takes over to forward packets for Host A.
To Next Page
Loading...
Need help?
General
