HPE FlexFabric 5940 SERIES

160
Specifying a format for the NAS-Port-ID attribute
RADIUS servers from different vendors might require different formats of the NAS-Port-ID attribute in
the RADIUS packets. You can specify the NAS-Port-ID attribute format as required.
The device supports the NAS-Port-ID attribute in format 1, format 2, format 3, and format 4. For more
information about the formats, see Security Command Reference.
To specify a format for the NAS-Port-ID attribute:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Specify the format for the
NAS-Port-ID attribute.
portal nas-port-id format
{
1
|
2
|
3
|
4
}
By default, the format for the
NAS-Port-ID attribute is format 2.
Specifying the device ID
The portal authentication server uses device IDs to identify the devices that send protocol packets to
the portal server.
Make sure the configured device ID is different than any other access devices communicating with
the same portal authentication server.
To specify the device ID:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Specify the device ID.
portal device-id
device-id
By default, a device is not
configured with a device ID.
Logging out online portal users
This feature deletes users that have passed portal authentication and terminates ongoing portal
authentications.
When the number of online users on the device exceeds 2000, executing the portal delete-user
command takes a few minutes. To ensure successful logout of online users, do not disable portal
authentication on any interfaces.
To log out online users:
Step Command
1. Enter system view.
system-view
2. Log out IPv4 online portal users.
portal delete-user
{ ipv4-address |
all
|
interface
interface-type
interface-number }
3. Log out IPv6 online portal users.
portal delete-user
{
all
|
interface
interface-type interface-number |
ipv6
ipv6-address }