167
Enabling logging for user logins and logouts
This feature logs information about user login and logout events, including the username, IP address,
user's MAC address, interface name, VLAN, and reason for login failure. For portal log messages to
be sent correctly, you must also configure the information center on the device. For more information
about information center configuration, see Network Management and Monitoring Configuration
Guide.
To enable logging for user logins and logouts:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable logging for user
logins and logouts.
portal log enable
By default, logging for user logins
and logouts is disabled.
Displaying and maintaining portal
Execute display commands in any view and the reset command in user view.
Task Command
Display information about MAC binding servers.
display portal mac-trigger-server
{
all
|
name
server-name }
Display portal rules.
display portal rule
{
all
|
dynamic
|
static
}
interface
interface-type interface-number [
slot
slot-number ]
Display portal configuration and portal running state
information.
display portal
interface
interface-type
interface-number }
Display portal authentication server information.
display portal server
[ server-name ]
Display portal Web server information.
display portal web-server
[ server-name ]
Display packet statistics for portal authentication
servers.
display portal packet statistics
[
server
server-name ]
Display portal user information.
display portal user
{
all
|
interface
interface-type
interface-number |
ip
ip-address |
ipv6
ipv6-address
|
pre-auth
[
interface
interface-type
interface-number |
ip
ip-address |
ipv6
ipv6-address ] } [
verbose
]
Clear packet statistics for portal authentication
servers.
reset portal packet statistics
[
server
server-name ]
Display Web redirect rule information.
display web-redirect rule interface
interface-type
interface-number [
slot
slot-number ]
To Next Page
Loading...
Need help?
General