EasyManuals Logo

HPE FlexFabric 5940 SERIES User Manual

HPE FlexFabric 5940 SERIES
571 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #352 background imageLoading...
Page #352 background image
339
[SwitchB-ipsec-transform-set-tran1] quit
# Create an IKE keychain named keychain1.
[SwitchB] ike keychain keychain1
# Specify 12345zxcvb!@#$%ZXCVB in plain text as the pre-shared key to be used with the
remote peer at 2.2.2.1.
[SwitchB-ike-keychain-keychain1] pre-shared-key address 2.2.2.1 255.255.255.0 key
simple 12345zxcvb!@#$%ZXCVB
[SwitchB-ike-keychain-keychain1] quit
# Create and configure an IKE profile named profile1.
[SwitchB] ike profile profile1
[SwitchB-ike-profile-profile1] keychain keychain1
[SwitchB-ike-profile-profile1] match remote identity address 2.2.2.1 255.255.255.0
[SwitchB-ike-profile-profile1] quit
# Create an IKE-based IPsec policy entry. Specify the policy name as use1 and set the
sequence number to 10.
[SwitchB] ipsec policy use1 10 isakmp
# Specify ACL 3101.
[SwitchB-ipsec-policy-isakmp-use1-10] security acl 3101
# Specify IPsec transform set tran1.
[SwitchB-ipsec-policy-isakmp-use1-10] transform-set tran1
# Specify the local and remote IP addresses of the IPsec tunnel as 2.2.3.1 and 2.2.2.1.
[SwitchB-ipsec-policy-isakmp-use1-10] local-address 2.2.3.1
[SwitchB-ipsec-policy-isakmp-use1-10] remote-address 2.2.2.1
# Specify IKE profile profile1.
[SwitchB-ipsec-policy-isakmp-use1-10] ike-profile profile1
[SwitchB-ipsec-policy-isakmp-use1-10] quit
# Apply IPsec policy use1 to VLAN-interface 1.
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ipsec apply policy use1
Verifying the configuration
# Initiate a connection between Switch A and Switch B to trigger IKE negotiation. After IPsec SAs are
successfully negotiated by IKE, the traffic between the two switches is IPsec protected.
Main mode IKE with pre-shared key authentication
configuration example
Network requirements
As shown in Figure 97, configure an IKE-based IPsec tunnel between Switch A and Switch B to
secure the communication between the switches.
• Configure the two switches to use the default IKE proposal for the IKE negotiation.
• Configure the two switches to use the pre-shared key authentication method for the IKE
negotiation.

Table of Contents

Other manuals for HPE FlexFabric 5940 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexFabric 5940 SERIES and is the answer not in the manual?

HPE FlexFabric 5940 SERIES Specifications

General IconGeneral
BrandHPE
ModelFlexFabric 5940 SERIES
CategorySwitch
LanguageEnglish

Related product manuals