383
b. In the Host Name (or IP address) field, enter the IP address 192.168.1.40 of the Stelnet
server.
Figure 100 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username and
password. After entering the username (client001 in this example) and password (aabbcc in
this example), you can enter the CLI of the server.
Publickey authentication enabled Stelnet server
configuration example
Network requirements
As shown in Figure 101, the switch acts as the Stelnet server, and it uses publickey authentication
and the RSA public key algorithm.
Establish an Stelnet connection between the host and the switch, so you can log in to the switch to
configure and manage the switch.
Figure 101 Network diagram
Vlan-int2
192.168.1.40/24
Stelnet client Stelnet server
Host
192.168.1.56/24
Switch
To Next Page
Loading...
