EasyManuals Logo

HPE FlexFabric 5940 SERIES User Manual

HPE FlexFabric 5940 SERIES
571 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #455 background imageLoading...
Page #455 background image
442
Configuring TCP attack prevention
Overview
TCP attack prevention can detect and prevent attacks that exploit the TCP connection establishment
process.
Configuring Naptha attack prevention
Naptha is a DDoS attack that targets operating systems. It exploits the resources consuming
vulnerability in TCP/IP stack and network application process. The attacker establishes a large
number of TCP connections in a short period of time and leaves them in certain states without
requesting any data. These TCP connections starve the victim of system resources, resulting in a
system breakdown.
After you enable Naptha attack prevention, the device periodically checks the number of TCP
connections in each state (CLOSING, ESTABLISHED, FIN_WAIT_1, FIN_WAIT_2, and LAST_ACK).
If the number of TCP connections in a state exceeds the limit, the device will accelerate the aging of
the TCP connections in that state to mitigate the Naptha attack.
To configure Naptha attack prevention:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable Naptha attack
prevention.
tcp anti-naptha enable
By default, Naptha attack
prevention is disabled.
3. (Optional.) Set the maximum
number of TCP connections
in a state.
tcp state
{
closing
|
established
|
fin-wait-1
|
fin-wait-2
|
last-ack
}
connection-limit
number
By default, the maximum number
of TCP connections in each state
(CLOSING, ESTABLISHED,
FIN_WAIT_1, FIN_WAIT_2, and
LAST_ACK) is 50.
To disable the device from
accelerating the aging of the TCP
connections in a state, set the
value to 0.
4. (Optional.) Set the interval
for checking the number of
TCP connections in each
state.
tcp check-state interval
interval
By default, the interval for
checking the number of TCP
connections in each state is 30
seconds.

Table of Contents

Other manuals for HPE FlexFabric 5940 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexFabric 5940 SERIES and is the answer not in the manual?

HPE FlexFabric 5940 SERIES Specifications

General IconGeneral
BrandHPE
ModelFlexFabric 5940 SERIES
CategorySwitch
LanguageEnglish

Related product manuals