234
Displaying and maintaining user profiles
Execute display commands in any view.
Task Command
Display configuration and online user information
for the specified user profile or all user profiles.
display user-profile
[
name
profile-name ] [
slot
slot-number ]
User profile configuration example
Network requirements
As shown in Figure 78, the device performs local 802.1X authentication on the users in domain user
for authentication and authorization efficiency.
Configure user profiles and QoS policies on the device to meet the following requirements:
• User A cannot access the Internet during 8: 30 and 12:00 every day even if User A passes
802.1X authentication.
• User B has an upload speed of 2 Mbps after passing 802.1X authentication.
• User C has a download speed of 4 Mbps after passing 802.1X authentication.
Figure 78 Network diagram
Configuration procedure
1. Configure a QoS policy for User A:
# Create a periodic time range from 8:30 to 12:00 every day.
<Device> system-view
[Device] time-range for_usera 8:30 to 12:00 daily
# Create IPv4 basic ACL 2000, and configure a rule to match all packets during the time range
for_usera.
[Device] acl number 2000
[Device-acl-basic-2000] rule permit time-range for_usera
[Device-acl-basic-2000] quit
# Create a traffic class named for_usera, and use ACL 2000 as the match criterion.
[Device] traffic classifier for_usera
[Device-classifier-for_usera] if-match acl 2000
[Device-classifier-for_usera] quit
To Next Page
Loading...
Need help?
General