Preparation procedures
Server data backup
Remove the front bezel
Power down the server
Remove the server from the rack
Remove the access panel
Remove the air baffle
Remove the PCI blank retainer
Remove a media drive
Power up the server
Removing and replacing the front bezel
Drive replacement
Removing and replacing a non-hot-plug LFF SATA drive
Removing and replacing a hot-plug LFF SAS or SATA drive
Removing and replacing a hot-plug SFF SAS or SATA drive
Removing and replacing drive blanks
Power supply replacement
Power supply warnings and cautions
Removing and replacing a Flexible Slot power supply
Removing and replacing the non-hot-plug power supply
Drive backplane replacement
Removing and replacing the 4 LFF drive backplane
Removing and replacing the 8 SFF drive backplane
Removing and replacing the power supply blank
Removing and replacing the media bay blank
Removing and replacing the air baffle
Media device replacement
Removing and replacing a SAS LTO tape drive
Removing and replacing a USB RDX docking station
Removing and replacing an optical drive
Fan replacement
Removing and replacing the PCI fan
Removing and replacing the system fan
Removing and replacing a DIMM
Heatsink replacement
Removing the heatsink
Installing the heatsink
Processor replacement
Processor cautions
Removing the processor
Installing the processor
To Next Page
Loading...
