hpmont HD3N Series - Appendix A Parameters; F15: Digital I;O Terminal Parameters (on pages 73 -83)

Appendix A Parameters Shenzhen Hpmont Technology Co., Ltd.
- 126 - HD3N Series User Manual V1.1
Ref. Code
Function Setting Range Default Unit Attribute Setting
F11.03
Enable feedforward of
motor current-loop
0: Forbid feedforward
1: Enable feedforward
0 1
×
F11.04
Motor excitation boost
setting
0.0 - 30.0% 0.0% 0.1%
×
F11.05
To optimize motor
magnatic field orientation
Unit: Orientation adjustment
0: Prohibit
1: Enable
Ten: Mutual inductance calculation
0: Prohibit
1: Enable
00 1
×
F15: Digital I/O Terminal Parameters (on pages 73 -83)
F15.00 DI1 function
0: Unused
1: Inverter enabled
2,3: FWD / REV
4: Three-wire running mode.
5 - 7,87: Frequency setting source
selection 1 - 4
8: Switch to analogue
9,10: Running command switching 1,
2
11: Command switch to terminal
12: External command for stop
13 - 16: Multi-speed frequency
terminal 1 - 4
17: Increase(UP) frequency.
18: Decrease(DN) frequency
19: Clear aux setting frequency to 0
20,21: FWD/REV jog 1 command
input (JOGF1 / JOGR1)
22,23: FWD/REV jog 2 command
input (JOGF2 / JOGR2)
24: Jog 1 command input
25: Jog 1 direction input
Note: when No. 20 and 21 are selected,
No. 24 and 25 are invalid.
26,27: Acc. / Dec. time terminal 1 and
2
28: Acc/dec mode selection
29: Forbid Acc. / Dec.
30: Switch to normal run
31: Reset infor PLC stop state reset
32: Pause process PID
33: Forbid process PID
34: PID integral holding
35: Clear PID integral
36: Wobble mode
2 1
×
F15.01 DI2 function 3 1
×
F15.02 DI3 function 0 1
×
F15.03 DI4 function 0 1
×