Shenzhen Hpmont Technology Co., Ltd. Chapter 6 Function Introduction
HD3N Series User Manual V1.1 - 45 -
Chapter 6 Function Introduction
This chapter will provide user with detail function introduction of each group.
Display parameter:
d00: Status Display Parameter (on pages 46 - 49)
General function parameter:
F00: Basic Parameters (on pages 49 - 52)
F01: Protection of Parameters (on pages 52 - 53)
F02: Parameters for Start and Stop (on pages 53 - 57)
F03: Acc. / Dec. Parameter (on pages 57 - 58)
F04: Process PID Control (on pages 58 - 61)
F05: External Setting Curve Parameter (on pages 61 - 63)
F06: Multi-speed and Simple PLC (on pages 63 - 66)
F07: Wobble Function Parameter (on pages 66 - 67)
F08: Asyn. Motor Parameters (on pages 67 - 69)
F09: V/f Control Parameters (on pages 69 - 71)
F10: Motor Vector Control Speed-loop Parameters (on pages 71 - 72)
F11: Motor Vector Control Current-loop Parameters (on pages 72 - 73)
F15: Digital I/O Terminal Parameters (on pages 73 - 83)
F16: Analogue I/O Terminal Parameters (on pages 83 - 86)
F17: SCI Communication Parameter (on pages 86 - 87)
F18: Display Control Parameter (on pages 87 - 88)
F19: Function-boost Parameters (on pages 88 - 95)
F20: Fault Protection Parameters (on pages 95 - 98)
F21: Torque Control Parameter (on pages 98 - 99)
F23: PWM Control Parameter (on pages 99)
R02: Analogue Parameter Correction Factor (on pages 100)
Manufacturer Function Parameters (on page 100)
To Next Page
Loading...
Need help?
General