Figure 4-8 Installing the front and rear ends of a holding rail
2. Insert the positioning pins on the rear of the rail into the square holes in the cabinet. See
(3) in Figure 4-8.
3. Align the front with a square hole, and push the holding rail forward until it snaps into
place. See (4) in Figure 4-8.
4. Push the hook backwards so that its metal sheet touches the mounting bar. See (5) in
Figure 4-8.
5. (Optional) Install an M6 screw in the third square hole at the rear of the holding rail to
secure it. See (6) in Figure 4-8.
Step 2 Install the server.
1. Pull out the inner rails as far as they will go. See Figure 4-9.
2288H V5 Server
User Guide
4 Setup
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 75
To Next Page
Loading...
