Huawei AR150 series - Page 111

NOTE
Only Layer 3 Ethernet interfaces on the main control board support Auto-Config.
If the received DHCP Reply packet contains Option 43, the auto-configuration server (ACS) is used for
deployment.
Figure 6-2 Auto-Config application
CPE
Eth 0/0/8
LAN
DHCP Server
DHCP Relay
FTP/TFTP Server
DNS Server
IP network
ACS Server
Pre-configuration Tasks
Before deploying routers, complete the following task:
l Ensuring that physical links between routers and the DHCP server and FTP/TFTP server
work properly
Data Preparation
To deploy routers, you need the following data.
N
o.
Data
1 Information about the interface that connects an AR150/200 to the DHCP server
2 Address pool of the DHCP server
3 IP address range and mask of the DHCP server
4 Egress gateway of routers
5 Option parameters of the DHCP server
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 6 Auto-Config
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
102