Huawei AR150 series - Configuring the FTP;TFTP Server

Step 10 Run:
option code { ascii ascii-string | hex hex-string | ip-address ip-address &<1-8> }
Option parameters of the DHCP server are configured.
If Option 67 is not configured, the process of obtaining the intermediate file is started.
NOTE
Pay attention to the following points when configuring option parameters:
l When the configuration file is obtained using TFTP, the DHCP server must support Option 150 or
support Option 6, Option 15, and Option 66.
l When the configuration file is obtained using FTP, the DHCP server must support Option 141, Option
142, and Option 143.
l When option parameters of TFTP and FTP are both set on the DHCP server, the FTP mode is preferred.
----End
6.3.3 Configuring the FTP/TFTP Server
Routers obtain configuration files after the FTP/TFTP server is configured.
Context
NOTE
l On an FTP server, the IP address must be the same as that contained in Option 143 configured on the
DHCP server. On a TFTP server, the IP address must be the same as that contained in Option 150 or
Option 6, 15, and 66 configured on the DHCP server.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ftp server enable
The FTP server is enabled.
NOTE
After the DHCP client obtains configuration files from the FTP server, run the undo ftp server command
to disable the FTP server immediately to ensure FTP server security.
Step 3 (Optional) Configure the authentication information, authorization mode, and working directory
for FTP users.
1. For TACACS authentication users:
l Run:
set default ftp-directory directory
The default FTP working directory is configured.
2. For AAA authentication users:
l Run:
aaa
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 6 Auto-Config
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
105