Huawei AR150 series - 2 Information Center Configuration

2 Information Center Configuration
About This Chapter
This chapter describes how to configure the information center to control the output of logs,
alarms, and debugging messages.
2.1 Introduction to the Information Center
The information center works as the information hub of a router. It classifies and filters the output
of a system. The information center uses a debugging program to help network administrator
and developers monitor network operation and analyze network faults.
2.2 Information Center Supported by the AR150/200
The information center outputs logs, alarms, and debugging messages at eight severity levels
through 10 information channels.
2.3 Enabling Log Output
This section describes how to output logs of a specific module to a log file, console, terminal,
or log host.
2.4 Enabling Alarm Output
This section describes how to configure a specific module to output alarm information to log
files, consoles, terminals, or SNMP agents.
2.5 Enabling the Output of Debugging Information
This section describes how to configure a specific module to output debugging information to
log files, consoles, terminals, or SNMP agents.
2.6 Maintaining Information Center
This section describes how to run the following commands to delete messages in the buffer of
the information center. Note that deleted messages cannot be restored.
2.7 Information Center Configuration Examples
This section provides information center configuration examples.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6