The channel through which debugging information is output to the terminal is configured.
2. Run:
quit
Return to the user view.
Step 3 Enable terminal display.
1. Run:
terminal monitor
Terminal display is enabled.
2. Run:
terminal debugging
Displaying debugging information on the terminal is enabled.
----End
2.5.7 Outputting Debugging Information to the Log Host
By outputting debugging messages to the log host, you can view debugging messages more
conveniently.
Procedure
Step 1 Configure debugging information to be output through the channel.
1. Run:
system-view
The system view is displayed.
2. Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ debug { state { off | on } | level severity }
*
]
Debugging information is added to the information channel.
Step 2 Configure the channel through which debugging information is output to the log host.
l (On an IPv4 network) Run:
info-center loghost ip-address [ channel { channel-number | channel-name } |
facility local-number |
{ language language-name | binary [ port ] } | { vpn-instance vpn-instance-
name| public-net } ]
*
The channel through which debugging information is output to the log host is configured.
By default, debugging information is not output to the log host after the information center
is enabled.
The system supports the configuration of a maximum of eight log hosts to realize backup
among log hosts.
----End
2.5.8 Checking the Configuration
After configuring the debugging message output, you can view the configuration of the
information center.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
33
To Next Page
Loading...
