The information channel through which logs are output to the terminal is configured.
2. Run:
quit
Return to the user view.
Step 3 Enable terminal display.
1. Run:
system-view
The system view is displayed.
terminal monitor
Terminal display is enabled.
2. Run:
terminal logging
The log display is enabled on the terminal.
----End
2.3.10 Outputting Logs to the Log Host
By outputting logs to the log host, you can view the operating status of the device on the log
host.
Procedure
Step 1 Configure the logs to be output through the channel.
1. Do as follows on the router configured with the information center, run:
system-view
The system view is displayed.
2. Run:
info-center source { module-name | default } channel { channel-number |
channel-name } [ log { state { off | on } | level severity }
*
]
Logs are added to the information channel.
Step 2 Configure the channel through which logs are output to the log host.
l (On an IPv4 network) Run:
info-center loghost ip-address [ channel { channel-number | channel-name } |
facility local-number |
{ language language-name | binary [ port ] } | { vpn-instance vpn-instance-name
| public-net } ]
*
The channel through which logs are output to the log host is configured.
By default, logs are not output to the log host after the information center is enabled.
The system supports the configuration of a maximum of eight log hosts to realize backup
among log hosts.
----End
2.3.11 Checking the Configuration
Checking the Configuration of Information Center
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18
To Next Page
Loading...
