Huawei AR150 series - Example for Outputting Alarms to the SNMP Agent

interface Ethernet1/0/0
ip address 10.1.1.1 255.255.255.0
#
info-center filter-id 1077514264
info-center loghost 10.1.1.6 binary
#
return
2.7.4 Example for Outputting Alarms to the SNMP Agent
After alarms are output to the SNMP agent, the NM Station can receive the alarms sent from
the device.
Networking Requirements
As shown in Figure 2-7, alarms are required to be output first to the SNMP agent and then to
the NM Station through SNMP Agent.
Figure 2-7 Networking diagram of outputting alarms to the SNMP Agent
NM Station
Agent
10.1.1.2/24
10.1.1.1/24
Eth1/0/0
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable the information center on the router.
2. Specify the module enabled to output logs and configure the channel through which the
alarm is output.
3. Enable the outputting alarm to the SNMP agent.
4. Enable transmitting alarms to the NM Station through SNMP.
Data Preparation
To complete the configuration, you need the following data:
l Information channel number
l Module enabled to output alarms
l Severities of alarms
Procedure
Step 1 Enable the information center.
<Huawei> system-view
[Huawei] info-center enable
Step 2 Specify the module enabled to output alarms and configure the channel used to output alarms.
# Specify the module enabled to output alarms and configure the channel used to output alarms.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
43