Huawei AR150 series - Maintaining Information Center

Prerequisites
The configurations of the debugging information function are complete.
Procedure
l Run the display channel [ channel-number | channel-name ] command to check the
configuration of a channel.
l Run the display info-center [ statistics ] command to check the information recorded by
an information center.
----End
Example
Run the display channel command. For example:
<Huawei> display channel 0
channel number: 0, channel name: console
MODU_ID NAME ENABLE LOG_LEVEL ENABLE TRAP_LEVEL ENABLE DEBUG_LEVEL
ffff0000 default Y warning Y debugging Y debugging
416e0000 ARP Y warning Y debugging Y debugging
Run the display info-center command. For example:
<Huawei> display info-center
Information Center: enabled
Log host:
Console:
channel number: 0, channel name: console
Monitor:
channel number: 1, channel name: monitor
SNMP Agent:
channel number: 5, channel name: snmpagent
Log buffer:
enabled
max buffer size: 1024, current buffer size: 512
current messages: 6, channel number: 4, channel name: logbuffer
dropped messages: 0, overwritten messages: 0
Trap buffer:
enabled
max buffer size: 1024, current buffer size: 256
current messages: 0, channel number: 3, channel name: trapbuffer
dropped messages: 0, overwritten messages: 0
Logfile:
channel number: 9, channel name: channel9, language: English
Information timestamp setting:
log - date, trap - date, debug - date
Sent messages = 25, Received messages = 25
2.6 Maintaining Information Center
This section describes how to run the following commands to delete messages in the buffer of
the information center. Note that deleted messages cannot be restored.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34