Huawei AR150 series - Information Center Configuration Examples; Example for Outputting Logs to the Log File

Context
CAUTION
Statistics about the information center cannot be restored after being cleared. So, confirm the
action before you use the command.
Procedure
l To clear statistics about the information center, run the reset info-center statistics
command in the user view.
l To clear statistics about the log buffer, run the reset logbuffer command in the user view.
l To clear statistics about the alarm buffer, run the reset trapbuffer command in the user
view.
----End
2.7 Information Center Configuration Examples
This section provides information center configuration examples.
2.7.1 Example for Outputting Logs to the Log File
This section describes how to output logs of a specific module or specific severity level to the
log file. This enables maintenance engineers to monitor the operating status of the device and
locate a fault by checking the output logs.
Networking Requirements
As shown in Figure 2-4, Router A is required to transport logs to a File Transfer Protocol (FTP)
server. Maintenance engineers can easily obtain the operating status of Router A and locate any
faults occurring on it.
NOTE
The default log storage medium is Flash memory. The log storage path is in the format of storage medium
name:/logfile, for example, Flash:/logfile.
Figure 2-4 Networking diagram of log output to the log file
FTP Server
RouterA
IP network
10.1.1.1/16
10.2.1.1/16
Eth1/0/0
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
35