Huawei AR150 series - Checking the Configuration

l If an Eth-Trunk is configured as a mirrored interface, its member interfaces cannot be
configured as mirrored interfaces. To configure a member interface as a mirrored interface,
delete it from the Eth-Trunk first.
l If a member interface of an Eth-Trunk is configured as a mirrored interface, the Eth-Trunk
cannot be configured as a mirrored interface. To configure the Eth-Trunk as a mirrored
interface, delete the member interface from it first.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
mirror to observe-server{ both | inbound | outbound }
The interface is configured as a mirrored interface.
observe-server-index is the index of the observing server, which must be identical with the
observing server index configured in 4.5.2 Configuring the Observing Server.
----End
4.5.4 Checking the Configuration
After remote port mirroring is configured, check the configurations of the observing server and
mirrored interface.
Prerequisites
The configurations of remote port mirroring are complete.
Procedure
l Run the display observe-server command to check the configuration of observing server.
l Run the display mirror-port command to check the configuration of mirrored interface.
----End
Example
Run the display observe-server command to check information about the observing server.
<Huawei> display observe-server
----------------------------------------------------------------------
Index : 1
destination-ip : 20.1.1.2
source-ip : 10.1.1.1
dscp : 0
Used : 1
----------------------------------------------------------------------
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 4 Mirroring Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
69