Huawei AR150 series - 3 Logging In to the Router

Content : Add the route [STRING] that have other flags besides deleted f
lag [USHORT]
Filtered Number : 0
2.4 Enabling Alarm Output
This section describes how to configure a specific module to output alarm information to log
files, consoles, terminals, or SNMP agents.
2.4.1 Establishing the Configuration Task
Before configuring the alarm output, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The device can generate alarms in specific situations to draw attention of the administrators.
Alarms can be output to the alarm buffer, log file, Console, terminal, and Network Management
System (NMS), through which the administrator can easily locate and rectify the fault.
Pre-configuration Tasks
Before enabling alarm output, complete the following tasks:
l Connecting the router and the NM station correctly
l Configuring routes between the router and the NM station
Data Preparation
To configure alarm output, you need the following data.
No.
Data
1
l Channel number
l Channel name
2 Module name
3 Severity level of alarms
4 (Optional) Size of an alarm buffer
5 IP address of Network Management System
2.4.2 Enabling the Information Center
If the information center function is disabled, you can enable it. By default, this function is
enabled.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
21