Huawei AR150 series - Outputting Alarms to the Console

For the alarm information, the state is on and the allowed information level is
debugging.
For the debugging information, the state is off.
Step 2 Configure the channel through which alarms are output to the log file.
1. Run:
info-center logfile channel { channel-number | channel-name }
The channel through which alarms are output to the log file is configured.
By default, alarms are output through Channel 9 to the log file after the information center
is enabled.
Step 3 (Optional) Configure the size of the log file output by the information center.
1. Run:
info-center logfile size size
The size of the log buffer is set.
By default, the size of log files is 8 MB.
----End
2.4.6 Outputting Alarms to the Console
By outputting alarms to the console, you can view the operating status of the device on the
console.
Context
Do as follows on the router configured with the information center:
Procedure
Step 1 Configure the alarms to be output through the channel.
1. Run:
system-view
The system view is displayed.
2. Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ trap { state { off | on } | level severity }
*
]
Alarms are added to the information channel.
For the specific modules, the default configurations are as follows:
For the log information, the state is on and the allowed information level is warning.
For the alarm information, the state is on and the allowed information level is
debugging.
For the debugging information, the state is off.
Step 2 Configure the channel through which alarms are output to the console.
1. Run:
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
24