Huawei AR150 series - 3.3 Logging In to the Router Using Telnet

info-center console channel { channel-number | channel-name }
The channel through which alarms are output to the Console is configured.
By default, alarms are output to the Console through Channel 0.
2. Run:
quit
Return to the user view.
Step 3 Enable terminal display.
1. Run the following command on the router configured with the information center:
terminal monitor
Terminal display is enabled.
2. Run:
terminal trapping
Displaying alarms on the terminal is enabled.
----End
2.4.7 Outputting Alarms to the Terminal
By outputting alarms to the terminal, you can view the operating status of the device on the
terminal.
Context
Do as follows on the router configured with the information center:
Procedure
Step 1 Configure the alarms to be output through the channel.
1. Run:
system-view
The system view is displayed.
2. Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ trap { state { off | on } | level severity }
*
]
Alarms are added to the information channel.
For the specific modules, the default configurations are as follows:
For the log information, the state is on and the allowed information level is warning.
For the alarm information, the state is on and the allowed information level is
debugging.
For the debugging information, the state is off.
Step 2 Configure the channel through which alarms are output to the VTY terminal.
1. Run:
info-center monitor channel { channel-number | channel-name }
The channel through which alarms are output to the VTY terminal is configured.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25