Huawei AR150 series - Configuration Examples; Example for Configuring Poe

Procedure
Step 1 Run the display poe-power command to view the status of the PoE power supply.
Step 2 Run the display poe device command to view information about the devices that support the
PoE function.
Step 3 Run the display poe information [ slot slot-id ] command to view the PoE information.
Step 4 Run the display poe power interface interface-type interface-number command to view the
output power of an interface.
Step 5 Run the display poe power slot slot-id command to view the output power of the interfaces on
the board in the specified slot.
Step 6 Run the display poe power-state interface interface-type interface-number command to view
the status of PoE power supply on an interface.
Step 7 Run the display poe power-state slot slot-id command to view the status of the PoE power
supply on the board in the specified slot.
----End
3.4 Configuration Examples
This section provides an example for configuring PoE on the AR150/200.
3.4.1 Example for Configuring PoE
This section provides an example of PoE power supply.
Networking Requirements
As shown in Figure 3-1, the requirements as follows:
l IP phones are connected to Ethernet 0/0/4 and Ethernet 0/0/5.
l Other PDs are connected to Ethernet 0/0/6 and Ethernet 0/0/7.
l The PD connected to Ethernet 0/0/6 has a high priority in power supply.
l The maximum output power of the PoE board in slot 0 is 100 W.
l The PD connected to Ethernet 0/0/7 requires the input power of no more than 20 mW.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 3 PoE Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
54