Huawei AR150 series - Page 47

Router sends the logs (with a severity level as warning) generated on the Point-to-Point Protocol
(PPP) module and the AAA module to the log host Server 1. Server 4 functions as a backup
router of Server 2.
Both the Router s and the log hosts need to be configured.
Figure 2-5 Networking diagram of outputting logs to the log host
172.16.0.1/24
Eth1/0/0
Router
Server1
Server 2
Server 4
Server 3
10.1.1.2/24 10.1.1.1/24
10.2.1.1/24
10.2.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable the information center.
2. Name the tunnel.
3. Specify the module enabled to output logs.
4. Configure the channel for outputting logs.
5. Configure the source interface that sends logs.
6. Configure the log host.
Data Preparation
To complete the configuration, you need the following data:
l IP address of the log host
l Information channel number
l Name of the channel through which logs are output
l Module enabled to output logs
l Information severity level
l Language in which the log is output
Procedure
Step 1 Configure routing protocols to make the router and log server routable. (The detailed procedure
is not mentioned here.)
Step 2 Configure the channel for outputting logs.
# Enable the information center.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
38