Huawei AR150 series - Page 55

1. Enable the information center.
2. Set the logs to be output to the console and the information module.
3. Configure the channel through which the debugging information is output.
4. Enable the terminal monitor function and display the debugging information.
Data Preparation
To complete the configuration, you need the following data:
l Information channel number
l Module enabled to output the logs
l Information severity level
Procedure
Step 1 Enable the information center.
<Huawei> system-view
Info: Current terminal monitor is on.
[Huawei] info-center enable
Info: Current terminal debugging is on.
Step 2 Allow the debugging on the ARP module to be output to the Console with the severity level of
the information as debugging.
[Huawei] info-center source arp channel console debug level debugging
[Huawei] info-center console channel console
[Huawei] quit
Step 3 Enable the terminal monitor function to display the debugging information.
<Huawei> terminal monitor
<Huawei> terminal debugging
Step 4 Enable ARP module debugging.
<Huawei> debugging arp packet
Step 5 Verify the configuration.
# View the configuration of the channel.
<Huawei> display channel 0
channel number: 0, channel name: console
MODU_ID NAME ENABLE LOG_LEVEL ENABLE TRAP_LEVEL ENABLE DEBUG_LEVEL
ffff0000 default Y warning Y debugging Y debugging
c16e0000 ARP Y warning Y debugging Y debugging
----End
Configuration Files
#
info-center source ARP channel 0
#
return
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 2 Information Center Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
46