Huawei AR150 series - Page 61

NOTE
Currently, only Ethernet 0/0/0 to Ethernet 0/0/7 on the SRU of the AR150/200 support PoE.
l Optional: Set the maximum output power of an interface.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
poe power port_max_power
The maximum output power of the interface is set.
The unit of port_max_power is mW.
NOTE
l By default, the maximum output power of an interface is 37 W.
l The maximum output power of a board is not equal to the maximum output power of an
interface multiplied by the number of interfaces on the board because not all interfaces on
the board can provide maximum output power at the same time.
l Optional: Set the power supply priority of an interface.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
poe priority { critical | high | low }
The power supply priority of the interface is set.
By default, the power supply priority of an interface is low.
The priorities in descending order are critical, high, and low.
l Optional: Manually power on or off the PD connected to an interface.
1. Run:
system-view
The system view is displayed.
2. Run:
poe { power-on | power-off } interface interface-type interface-number
The PD connected to an interface is powered on or powered off manually.
NOTE
When the manual power management mode is adopted, you must manually power on or power
off PDs on interfaces.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Device Management 3 PoE Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
52